Change Client Password

 

The Time Clock Client Enable Checkboxes are used to set a password for Open and /or Close of the Employee interface program. This is important to have control over your data that you at least set it for Closing the Client program unless you are using the Internet Time Servers. If you use the Internet Time Servers, there is no need for a password in the client program. Simply check the options that you wish to use.

 

 

This is where you will enter the password that you want to use for the Employee interface program. If you have an existing password, enter that in the top entry and enter the password that you want to use in the two lower entries.

 

The Remove Password will remove any existing passwords that were set.

 

 

Enter the existing password to change to a new password.

 

 

Enter the new password you want to use.

 

 

Enter the new password again to confirm that there are no typos.

 

 

This button will remove any existing password.

 

 

This button will save your changes.

 

 

This button will cancel your actions.